Menu

You Are Here: Home      Products      Roof Coatings      MaxiPoint

MaxiPoint

Permanent Pointing Every Time

Maxi Point is a viscous, ready to use roof pointing mortar that is easy to use and very durable. Maxi Point is available in a range of colours to suit new and renovated roofs.

Applications & Features

Permanently Flexible

Manufactured from a pure grade internally flexibe acrylic resin to provide permanent flexibility over a wide temperature range and diverse weather conditions.

Smooth to Trowel

Maxi Point does not contain sticky thickeners and the fillers are specially graded to optimize trowel slip, improve application and finishing properties.

Fast Drying

The high resin solids formula of Maxi Point needs to lose less water during curing compared to competing products. In very cold or moist weather conditions drying time can be further accelerated, by adding 375mls of Builders Cement, per 10 litres of Maxi Point. Stir in cement thoroughly. The unused product will set hard quickly and cannot be saved and re-used. Do not add water to retard the curing of Maxi Point after the addition of the cement.

Fade Resistant

The pure grade acrylic and high-quality pigments in Maxi Point are resistant to UV light damage and moisture which would otherwise cause fading and loss of durability.

Paintable

Maxi Point can be easily painted with any Nutech water-based polymer coating including Nu-Prime, GP Primer, Master Sealer, Membrane, Nu-Flex, TileFlex 2000, Asbestos Primer, Insulguard and DecraTex. Surfaces coated with Perm-Point can be re-coated with Maxi Point.

Guaranteed

Maxi Point is guaranteed to resist normal occurring roof movements for 10 years without cracking or breaking away.

Meets Australian Standards

Maxi Point complies with the provisions of the Australian Standard AS 2050-1995 Roof Fixing and accredited with a C3 wind classification.

Application Guide

Application by trowel of a thin film between 3mm and 5mm thick is recommended using a similar technique to conventional pointing mixes. Sponge finishing is not recommended.

New Tile Roofs

Bedding cement should be finished plumb and free of holes and voids. Fresh bedding does not require cull curing before application of Maxi Point. However, it should be dry enough to resist trowel pressure.

Old Tile Roofs

Crumbly cracked and loose unstable bedding and pointing should be replaced. Where pointing over sound old bedding and pointing, the surface must be clean and free of dirt, moss, lichen and other contamination. Maxi Point cannot be expected to adhere to unless the substrate is sound and clean. All existing collars should be removed and the roof re-pointed with new collars.

Storing

Properly re-seal the pail before storing to preserve shelf life. The product must be stored indoors and out of direct sunlight. Prevent product freezing. Storage temperatures should be between 3°C and 45°C.

MaxiPoint
Quick Reference

Suitable Surfaces

Terracotta Tiles

Appearance:

Coloured stiff mortar mix

Solubility:

Water

Film Forming Temperature:

5°C

Dry Film Thickness:

3 - 5mm minimum

Touch Dry:

30 minutes (at 20°C)

Coverage Rate:

25 - 27 lm/10L m2/L

Properties

Water Based

Water Clean-up

Related Products:

Important Notice

The information given in this data sheet is based on many years experience and is correct to the best of our knowledge. However as the use of our product is beyond our control we can only be responsible for the quality of our product at the time of dispatch. For additional information about specifications or application please contact our company. As this information is of a general nature we cannot assume responsibility for individual use.